Internal Clutch Assembly
Ingenious design completely eliminates the
clutch pipe and housing. Converts the end of the handlebar into a single cable clutch. The clutch cable is routed through the bar so all components are hidden from view. For custom motorcycles only.
For 1" bars.
For custom motorcycles only. Requires
cutting the left bar end to install
After the handlebars are prepped and ready, insert clutch cable through the hole in the handlebar until the cable comes out at the clutch end. Remove the end cap screw from the outer sleeve. Remove the outer sleeve completely by rotating clockwise. Do not lose the rollers. Due to variations in the rollers install in the same order they are removed. Once the outer sleeve is removed, slide the rollers away from the set screw. Locate the set screw on the inner sleeve. Insert clutch cable end into the slider then tighten the set screw using a small amount of blue loctite (medium strength). Re-assemble the clutch control. Insert the inner sleeve into the handlebar end. Align the set screw holes. Tighten set screw until flush with the handlebar using blue loctite (medium strength).