18" Rise Ape Hangers "El Diablo" Fat 1-1/4" Diameter with Hand Controls for Harley Motorcycles

Chrome 18" Rise 'El Diablo' Ape Hangers
with Smooth-Contour Control Kit
and Chrome Switches

This listing is for complete 1-1/4" fat handlebar set-up. All components are triple-plated chrome top quality parts, featuring smooth hidden mounting hand controls, hidden wiring and chrome switches.

All components are brand new and have been assembled by professional Harley-Davidson certified mechanic.
Official Harley-Davidson service guidebook rates the hand switches wire installation job as a 2.5 hour job, valued at $235.

This handlebars come fully and professionally assembled, ready to be installed on your motorcycle in minutes.

Here is what you are getting:

Smooth-Contour Hand Controls
Unique design has hidden underside mounting
on the switch housings for
an unobstructed smooth, rounded surface on the top housing.
BETTER LOOK AND CHROME THAN ANY HD PRODUCT.

9/16" Bore master cylinder. For Single disc application

(Please contact us first if you are looking for a dual disc set-up)
Hydraulic Hand controls also Available 

This is top quality kit.
Much higher quality than HD or any aftermarket product. Simply the best.
Made in U.S.A.

Retail $402.99

----------------------------------------------------------------

Chrome 'El Diablo' Apehangers
18" Rise 1-1/4" Handlebars

Show chromed!
18" rise. 8" backward sweep. 1 1/4"-diameter. Center section tapers to 1" so that standard handlebar controls fit.
34-1/2" wide from tip to tip.
Come with drilled wiring holes.

Retail $210.99

--------------------------------------------------------------

Chrome Switches and Wire Harness

High quality USA made chrome switches for hand controls.
Wires are soldered and color-coded for easy installation.

Retail $206.99

---------------------------------------------------------------

Total package price: 402.99
210.99
206.99
Professional Installation 235.00
_________________
Total: $1055.97

How to Install New Handlebars:

Ever notice how most fine artists depict the devil? They draw this demon from hells wings as having sharp angles. This vision was not lost on Demons Cycles. Its new 1-1/4" inch El Diablo handlebars sure remind us of devil wings. No matter the imagery, we thought they have a real cool look, as did Navy Seaman Mario Guerrero.

The El Diablo handlebars owe their sinister look to their severe angles and gusset plates. They are

1. Fabricated from 1-1/4" inch tubing and powder coated black.

2. Our starting point, a 2007 Dyna Street-Bob: the dash, gas tank, and hand controls already have been removed.

3. The new handlebars have oblong holes to run the control wiring in and out through.

4. Air nozzle is used to blow the lead string through the bars,Then a length of rope is attached to the string and pulled through the bars.

5. The rope was used to pull the controls wire harnesses through the bars.

6. The factory risers were used to mount the new bars.

7. Because the bars are 1" inch in diameter at their center mounting position, a stock clamp was used

8. The control switches were mounted to the bars and their harnesses fined over the top triple tree and routed into the frame.

9. The switch wiring exits the front of the switch housing and into the bars.

10. Once the switch housing were in the place the front brake and clutch levers were attached to the bars

11. These stunning bars sure remind us of devil wings.